Listing Tools

Welcome to 8616 Etta Drive, a stunning brick-front Radcliffe model sited on a 1/3-acre lot backing to trees in Springfield's desirable Keene Mill Station. This home features dazzling hardwood floors in the entryway, living, dining, family rooms and master bedroom. The attractively updated kitchen offers lots of 42-inch maple cabinets, granite counters with custom tile backsplash, and stainless-steel appliances. Just off the kitchen is the large recently installed deck. Relax by the cozy fireplace in the family room with custom built-ins on each side. The sump pump was new in 2019 and the garage door and vinyl siding on the rear of the house were also replaced. There's a sitting room in the master suite along with ample closet space and en suite bath. The terrific walk-out lower level offers a spacious rec room with new modern wide-plank flooring and recessed lighting, a half bath, laundry room and a new sliding glass door leading to the expansive rear grounds. This fine home is ideally located with easy access to Fairfax County Parkway, all major commuter routes, Fort Belvoir, and just minutes to Franconia-Springfield Metro and VRE.

Property Details of 8616 Etta Dr

Property Details

Interior Features

  • Waterfront: N
  • Appliances Included: Built-In Microwave, Dryer, Washer, Dishwasher, Disposal, Refrigerator, Icemaker, Stove

Utilities and Appliances

Community

Other Details

Map Location

Driving Directions

Listed by Cynthia Schneider of Long & Foster Real Estate, Inc.

Listing Sold by Keller Williams Realty

Hi there! How can we help you?

Contact us using the form below or give us a call.

Send Us A Message:

Do not fill in this field:

Hi there! How can we help you?

Contact us using the form below or give us a call.

Send Us A Message:

Do not fill in this field:

Hi there! How can we help you?

Contact us using the form below or give us a call.

Send Us A Message:

Do not fill in this field:

Do not fill in this field:

Do not fill in this field:

Do not fill in this field:

$

Do not fill in this field: